Skip to main content

Step Type:

Drag to rearrange

Locate (3) of the #4 x 3/8" sheet metal screws (30250).

Align the holes in the PCB with the holes in the PCB mount and insert the screws in to each of the three locations. DO NOT TIGHTEN YET

Ensure that the thermistor legs still have a slight arc and are not in the direct rear of the hot end where they can be pinched.

Tighten each of the three screws two complete turns and then check the thermistor legs.

Repeat as necessary until fully tightened.

Your contributions are licensed under the open source Creative Commons license.