Skip to main content

Step Type:

Drag to rearrange

If you have received a REV6 accelerometer board, this step is NOT required.

Locate the (2) Header 2 Pin JST PH2.0 (26176)

Insert and orient the parts as shown in the picture. The solid face of the plug should be facing towards the center of the hot end.

Solder those two plugs (4 total solder points in place from the bottom side of the HE280 Hotend PCB board.

If you pinch the leads on the white connectors a tiny bit, they'll "grip" the PCB and make them easier to solder.

Your contributions are licensed under the open source Creative Commons license.