Editing Step 11 —
Preparing the Heater Block

Step Type:

Drag to rearrange

Locate the Heater Block (71216), 12v 40 watt Heater Cartridge (26789), and (2) M3 -.5 x 10mm Phillips Pan Head Machine Screws (30318)

Insert the heater cartridge into the side of the heater block. The leads of the heater cartridge should stick out of the side of the heater block with 3 holes. The leads should be in a horizontal orientation and NOT VERTICAL. The heater cartridge should be inserted so that it is flush on the opposite face of the heater block.

Secure the heater cartridge in the heater block by tightening both of the M3 - .5 x 10mm screws.

Be sure to get these M3 - .5 x 10mm screws tight.

Your contributions are licensed under the open source Creative Commons license.