Rostock Max v3.2
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
Introduction
Details
Guide Steps
Review
Quiz
You will now install the 3 idler assembles on the base plate. These are the assembles WITHOUT the motors.
Install the 3 side panels with the smooth side facing OUT, as shown in the photo.
Tabs in the plates of the assembly align with cutouts in the base plate. Press the assembly into these cutouts.
You will secure each assembly with (2) 6-32 x 1" screws. This may be done easiest by cantilevering the base plate over the edge of a table. After you have all (6) screws started you can flip the assembly over and fully tighten.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.