Skip to main content
Editing Step 50 —

Step Type:

Drag to rearrange

Install the wires coming from the fuses in the locations indicated in the photo.

NOTE: If you purchased a machine after 8/22/2018 you will not need to install the 5A or 15A fuses. Connect the 20awg red wire from the hotend whip and the 12awg black wire from the tower directly to the green terminals indicated in the photo.

Make sure the green terminal block DOES NOT twist, it could rip off and cause you to replace your entire Duet! You may need to CAREFULLY hold it with pliers while tightening the screw.

Install the 5A and 15A fuses in their respective locations, and install the fuse plate using the SHCS 10/32 cap screws.

Your contributions are licensed under the open source Creative Commons license.