Step Type:

EDIT

You'll be making three of these assemblies using injection molded parts 84407 & 84408 ( 1 each per assembly). This animation is an overview of the assembly. Before you begin, review the following steps. The next step will also cover this assembly and break it down in steps.

When inserting the nylon lock nuts, do so from the "inside" of the injection molded part. This will allow the nut to fit more easily into the nut pocket. Needle nose pliers make this a breeze.

Only thread the t-slot nuts on a few threads - you need to leave room for the tower channel to slide between the t-slot nut and the face of the injection molded mount.

The threads on the t-slot nuts have a flange on one side. The flanged side should be away from the head of the screw.

Your contributions are licensed under the open source Creative Commons license.