REV2 Rostock Max v3 Assembly (4/12/2017)
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
Introduction
Details
Guide Steps
Review
Quiz
The whip connections specifically are noted below.
You should begin by connecting the red and black 18awg wires to a 2 position terminal block (found in RAMBo kit). Note the polarity in the photo.
Next, connect the orange wire to a 2 position terminal block (found in RAMBo kit). Note the polarity in the photo.
Next, connect the remaining wire to the board. These connection are pre-terminated and connect to the position noted in the pic.
Plug in the RAMBo cooling fan. The connection will be made in the bottom right hand corner of the board. This location is indicated in the third image.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.