Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 34 —

Step Type:

Drag to rearrange

To install the arms, snap (2) ball cup arms onto a set of carriage ball joints.

Insert the tensioning spring between the arms in the slot.

Do this for all three sets of arms.

Next, you will attach the arms to the hot end. When installing the hot end: The fan in the upright position blowing across the hot end should be parallel with the Z (back) tower & The 8 pin connector should be in line with the Y axis (front right). Insert the tension spring into the arms and then snap the ball cup arms onto the ball joints.

Connect all three sets of arms to the hot end.

Ensure that you have installed the hot end in the correct orientation. Refer to the 3rd image.

Your contributions are licensed under the open source Creative Commons license.