Editing Step 22 —
Install Extruder Side Plate

Step Type:

Drag to rearrange

Insert 6-32 nylon lock nuts into the nut traps on the injection molded base sides.

Install the first base side between the X & Z towers.

Secure the base side with (2) 6-32 x 1" screws.

Fasten the EZR Struder side plate to the base side plate using (2) 10-32 socket head cap screws. The holes in the injection molded side panels are not tapped / threaded. Make sure you put some pressure on the screws and keep them straight.

Route the wires around the top assembly clockwise as before. You will route through the same locations as the other stepper motor wires.

Plug the extruder stepper motor into the E0 location on the RAMBo board.

Your contributions are licensed under the open source Creative Commons license.