Machine Elements & Upgrades
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Introduction
Details
Guide Steps
Review
Quiz
You will now need to trim the PTFE length to fit the extruder.
For the older EZStruder you will be trimming the PTFE so it seats in the bottom of the brass PTC fitting.
For the newer EZR Struder, you will be trimming the PTFE so it seats in the bottom of the filament path in the EZR Struder body (Approximately 40mm from the end of the extruder).
YOU MUST NOT USE SCISSORS. YOU MUST USE A SHARP BLADE SUCH AS A UTILITY OR HOBBY KNIFE.
Measure Twice Cut Once!
Seat the PTFE tube in the extruder once you have it cut to length.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.