Gently pull any slack wire/whip from the front of the printer. The side panel with the extruder should still be removed, do not pull so much wire/whip that the cover is moved (we want to be left with enough slack that the cover can be removed in the future is maintenance is required.

Coil the wire once and add a cable tie to secure it. (Shown in the image with a black circle)

Cut the excess portion of the cable tie.

Route the wires on either side of the RAMBo board as shown in the picture.

No wires can be routed over the top of the RAMBo board. This will not permit the RAMBo to have enough room to be mounted back into the printer.