1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
The next connections involve using latching connectors, this means that there is only one way to plug them in. This will ensure that the polarity is correct.
Insert the 2 pin latching connector with the green and white wire into the T0 location on the RAMBo board.
Insert the 2 pin latching connector with the blue wire into the PS-ON location on the RAMBo board.
Insert the 4 pin latching connector with the red and black wire into the I2C location on the RAMBo board.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help