Artemis 300
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
Introduction
Details
Guide Steps
Review
Quiz
The brown wire exiting the Z tower with NO connector on it will install in the only empty clamp on the relay.
You may need to strip a little extra of the sheathing off this wire.
Unscrew the clamp on the relay just enough to insert the wire.
Insert the wire as close to the center of the clamp where the screw is as possible, then tighten the screw to clamp the metal plate down on the wire.
Make sure not to tighten the screw too much!
You're now done with the top wire connections!
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.