Artemis 300
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
Introduction
Details
Guide Steps
Review
Quiz
The Bowden Tube is the clear tube that delivers the filament from the extruder (EZR Struder) to the hot end (SE300).
Bunch the mesh loom up approximately 100mm from the top of the extruder and insert the Bowden Tube.
Push the Bowden Tube through the whip until you feel it 25-50mm from the "Y" in the whip.
Bunch the mesh loom up near where you feel the Bowden Tube and push the tube out through the loom.
Contrary to the second photo, do not insert the Bowden Tube into the hot end yet.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.