(Note that there are no photos for this step.) Cut the Layer fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "Layer" so you can identify them later.

Cut the PEEK fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "PEEK" so you can identify them later.

Measure 1-1/4" from the top of the melamine hot end mount and cut the four wires leading to the hot end.

Using your Phillips screwdriver & 5/16" wrench, remove the three screws that hold the hot end to the effector platform.

We're now ready to start adding connectors!