Machine Elements & Upgrades
View
Options
History
1
2
3
4
5
6
7
8
Introduction
Details
Guide Steps
Review
Quiz
The photos in this step show you the hardware you'll need before you can begin work.
Image #1 shows the three #6-32 thumbscrews, 1" threaded standoffs and the three #6-32 x 3/8" screws used to attach the standoffs to the effector platform.
Image #2 shows the required male & female JST connectors that will be used to wire up the PEEK and layer fans.
Image #3 shows the 4 pin latching connectors that are used to wire up the hot end power and thermistor connections.
« Introduction
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.