Jeremy Vanseader

As of this date, there IS a preset option for the H2 so I used that. Seems ok so far.

I got a warning about low memory during the upload, but its nothing to worry about. Works fine.

To save you scrolling, these blue things are going to be to hold down the glass

To remove the tube, you have to pull out the black ring part, and keep it held out while you remove the tube.

How do we know which xy is x and which xy is y?

On my base plate, there are more holes than appear in the picture. If you lay the board on the base plate, you can find which holes it lines up with. I suggest using washers on both sides of the base plate as the screw and the peg can both kinda fit in the hole. As the hole is so big, you probably need to adjust the positioning later for the board.

It appears that the inner and outer spring arms are no longer how it is. Both halves are identical with a bearing going on each half, then fitting the two together. The bearing fitting is VERY tight and I’m hesitant to hammer them on to the post.