Remove the 3 screws holding the SE300 board to the platform. These are shown in Pic 1 with red arrows.
Slightly lift the hotend and this will expose the 3 layer fan plugs as shown in Pic 2.
Unplug the fans from the SE300 boards as shown in Pic 3.
You can now lift the hotend and circuit board away from the platform and set the platform to the side.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.