Richard Dolan

Link to the RostockMax 3mf file is broken

Added in a “clean up wiring” step here, and zip tied the extruder motor wires

Last bullet should read “Leaving an empty plug next to the ORANGE as shown in pic 3”

Bummer for OCD first v4 buyers - SeeMeCNC offset to the left is killing me!

Thank you for listing the parts in this step!

Looks like for the v4 you need to grab these from the arm pack

With the Rostock Max v4 it seems like you are supposed to use two screws in each of the spring arm assemblies.

Also - once both halves are together - use the vice again to pull the halves together and set both bearings in the arm all the way down. Worked beautifully.

If you have a flat/smooth faced vice it works pretty well to get these on. Slowly, but it easily gets the arm through the bearing and flush with the black rim.