1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Bend the heater wires up so they are in line with the green connector
Trim the wires approximately even with the bottom of the PCB as shown in Pic 2
Strip the ends of the wires approximately 3mm (a little less than the height of the green connector as you do not want the wires exposed when connected.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help