Editing Step 11 —
Install Fan Shroud on Hotend

Step Type:

Drag to rearrange

Insert the fan shroud over the heat sink . There is a tab on the fan shroud that inserts into the first large gap between the fins on the heat sink. Press this tab fully into the heat sink.

Rotate the fan shroud so it is positioned in pic 2. The fan should be approximately at the corner of the heater block opposite of the thermistor wires.

Locate the SE300 PCB, knurled locking connector and small PTFE tube from the kit as shown in pic 3 for the next step.

Your contributions are licensed under the open source Creative Commons license.