Editing Step 6 —

Step Type:

Drag to rearrange

The RAMBo board is mounted to a backer board. You will grasp that backer board on the bottom left and right pull out. The bottom of the RAMBo (and backer) should pull freely and tip out. Once the top ears on the backer board have cleared the top plate of the base, the entire board can be removed.

Remove the 6 pin pluggable terminal block from the RAMBo board. (This terminal block has the wires that come from the power supply)

Loosen and remove ONLY the wire from the Fan 0 + terminal on the top of the RAMBo board.

Your contributions are licensed under the open source Creative Commons license.