Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 11 —

Step Type:

Drag to rearrange

Cut 2 pieces of heat-shrink at 15mm each. (This was included with the hot end whip)

Slide a 15mm long heat-shrink tubing over the red wire that is in the 4 pin latching housing. (as shown in the picture)

Slide a 15mm long heat-shrink tubing over the black wire that is in the 4 pin latching housing. (as shown in the picture)

Perform an in-line splice of the wires, Red to Red, Black to Black.

Solder the connections.

Your contributions are licensed under the open source Creative Commons license.