Locate the heater block, nozzle, and heatsink body you just disassembled.
Screw the heat break and heatsink into the heater block watching the threads of the heat break until the end of the threads are just about even with the the heater block.
The heat sink screws into the heat block into the side opposite the screw that clamps the heat cartridge.
Screw the nozzle into the heater block on the side with the screw and set screw as shown in pic 1.
Use an adjustable wrench or 6mm socket to tighten the nozzle. The nozzle tightens against the heat break to create a seal inside the heater block.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.