Skip to main content
Editing Step 2 —

Step Type:

Drag to rearrange

Locate the (12) R4 bearings and (24) black bearing covers.

Start by laying a sleeve half on the table, face up. Set an R4 bearing into it and firmly press it into place.

Set another sleeve half on the table and press the R4 bearing and sleeve into the new sleeve half to complete the carriage wheel.

Note that the sleeves have a sharp edge to them where they were cut free from the bulk stock during manufacture. Take special care not to injure yourself on this edge. It can easily be removed with a razor knife if you so choose.

Complete this process for all 12 of the supplied bearings.

Your contributions are licensed under the open source Creative Commons license.