1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
Choose the location that you want to route the new hotend whip.
In the pictures I show two locations. The location with the blue arrow shows where the original whip was routed.
The location with the green arrow is where I chose to route the hot end whip. (note.I used a panel mount strain relief, not included)
Ultimately the choice is up to you.
Run the new hotend whip through the top plate. You will need to route the end of the whip without any connector up through the plate.
At this point it does not matter how much of the whip is below the top plate. There needs to be plenty of slack in the top though to perform the required solder connections.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.