The spring arms consist of an inner and outer halves that retain two of the R4ZZ bearing rollers you assembled in Step #1.
Set two RZ44 bearings on the inner spring arm as shown in photo #2.
Press fit the outer spring arm on to the two small posts protruding from the inner spring arm. The fit is very tight, but they will fit!
In order to fully seat the pins once they're started in the holes, you can tap them in using the back end of your screwdriver as a hammer.
Assemble three complete sets.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.