RostockMAX v4
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Introduction
Details
Guide Steps
Review
Quiz
Your Duet should reboot and reconnect automatically. After it does this, you should notice two tools listed on the interface now. This means you did everything right!
Enjoy Dual Extrusion on your SeeMeCNC RostockMAX v4!
You may need to re-calibrate after this installation. If so, follow this guide to do so.
Check out this guide for preparing for Dual Extrusion in Cura
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.