Editing Step 20 —
Re-inserting the PTFE Tubes

Step Type:

Drag to rearrange

Install the PTFE tubes into the Y Adapter and clip the lanyards in place, just as you did on the EZR Struder

Remember to press the PTFE tube in further once the lanyard locks the PTC fitting in to fully seat the tube.

If you are following this guide as a side track from your RostockMAX v4 DIY KIT assembly, go back to that guide at this point and return here when you're done with your build and configuration.

Your contributions are licensed under the open source Creative Commons license.