Skip to main content
Help
Editing Step 3 —

Step Type:

Drag to rearrange

It's recommended to pull the PTFE tube back and exit it from the mesh loom further up the whip after performing this change.

You will also need to pull more of the whip out of the exit location on the machine.

On the RostockMAX V3.2 carefully pulling the whip a few extra inches through the black housing will work just fine.

On the Artemis you may not need to pull extra whip length out. If you do, you can rotate your extruder assembly up and carefully pull some extra whip length out of the tower. Don't force it. If it's not coming out with a decent gentle tug, leave it and contact us to get a replacement whip of the current revision.

Your contributions are licensed under the open source Creative Commons license.