Your machine was fully assembled, calibrated and printed successfully before it left our factory. We have done some things to make sure the machine does not get damaged while shipping the printer. Please complete the following steps

Carefully remove all shrink wrap from the printer. Be careful not to cut the machine if you are using a knife.

The arms have been inverted to prevent the hot end nozzle from striking the glass print surface during shipping. To invert the arms from shipping position to printing position, place your hand on ONE of the carriages and slowly move this carriage upward toward the top of the printer.

Next select one of the two remaining carriages and repeat.

Do the same operation with the final carriage.

Remove the BLUE calibration print from the print bed. (we leave that on there for you to see that your printer has been calibrated and printed on and is ready for printing)