Skip to main content

You're viewing the latest revision of this guide.

Older Newer
  1. 1. Put your printer's IP address into the command bar on your browser to open the Duet web interface
    • 1. Put your printer's IP address into the command bar on your browser to open the Duet web interface

    • 2. Go to Settings, then System Editor

    • 3. Click on config.g

  2. These are the values for 1.8 degree stepper motors  otherwise skip to Step 3
    • These are the values for 1.8 degree stepper motors otherwise skip to Step 3

    • Change values of these two lines starting with "M92 ....."

    • 1.8 degree stepper and 20 tooth pulley settings:

    • M92 X80 Y80 Z80

    • M92 E91.0:91.0

    • 1.8 Degree stepper and 16 tooth pulley settings:

    • M92 X100 Y100 Z100

    • M92 E91.0:91.0

  3. These are the values for 0.9 degree stepper motors.
    • These are the values for 0.9 degree stepper motors.

    • Change values of these two lines starting with "M92 ....."

    • 0.9 degree stepper and 20 tooth pulley settings:

    • M92 X160 Y160 Z160

    • M92 E182.0:182.0

    • 0.9 Degree stepper and 16 tooth pulley settings:

    • M92 X200 Y200 Z200

    • M92 E182.0:182.0

SeeMeCNC

Member since: 10/04/2016

562,208 Reputation

16 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 9

All Time: 2,433