Just slice and print. Don't change a thing. Drop an STL into Cura and click "Slice", "Preview" to preview the sliced file, then "Save to File".
Cura expert mode has about a zillion combinations of choices, so it's tricky no matter how good your are. We've invested some time to make general purpose profiles to slice most parts. Try them before adjusting anything.
Standards for SeeMeCNC Delta's for Cura 4-2-1 and higher, single or dual extrusion:
Filament starts 160mm above nozzle
Bed probe using the "Probe Autolevel" macro we wrote
Probe with hotend room temp and bed hot
Only turn on or off the "Generate Supports" check box under "Support" when getting started
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.