Changes to Step #9
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Installing Heater Cartridge |
|---|---|
| + | [* 1] Insert the heater cartridge into the heater block. The wires from the heater cartridge should exit the same side the set screw is on that holds the thermistor in place. |
| + | [* 1] Tighten the screw to secure the heater cartridge in place. You can use pliers to hold the block in place while tightening the screw. |
| + | [* 1] Locate the thermistor cartridge and allen key. |
| + | [* 1] Insert the thermistor FULLY (you may need to loosen or remove the setscrew that is pre-installed so the thermistor cartridge can be fully inserted. |
| + | [* 1] Use the allen key to tighten the set screw to hold the thermistor in place. |
| + | [* 9] DO NOT OVERTIGHTEN the set screw for the thermistor. Once the set screw is snug, you only need to turn about 1/2 turn beyond to tighten. Over tightening can damage the thermistor |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added