Changes to Step #14
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Prep Heater Wires |
|---|---|
| + | [* 1] Bend the heater wires up so they are in line with the green connector |
| + | [* 1] Trim the wires approximately even with the bottom of the PCB as shown in Pic 2 |
| + | [* 1] Strip the ends of the wires approximately 3mm (a little less than the height of the green connector as you do not want the wires exposed when connected. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added