Changes to Step #11
Step Lines
| [title] Install Fan Shroud on Hotend | |
| - | [* 1] Insert the fan shroud over the heat sink . There is a tab on the fan shroud that inserts into the first large |
| + | [* 1] Insert the fan shroud over the heat sink . There is a tab on the fan shroud that inserts into the first large gap between the fins on the heat sink. Press this tab fully into the heat sink. |
| [* 1] Rotate the fan shroud so it is positioned in pic 2. The fan should be approximately at the corner of the heater block opposite of the thermistor wires. | |
| [* 1] Locate the SE300 PCB, knurled locking connector and small PTFE tube from the kit as shown in pic 3 for the next step. |