Changes to this Step
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Install Thermistor |
|---|---|
| + | [* 1] Get the thermistor from the kit. This is the brass cartridge with two white wires and a plug on it. |
| + | [* 1] Insert the brass thermistor cartridge into the heater block as far as it will go. You may have to use the allen key provided to loosen or remove the set screw in order to insert the thermistor fully. |
| + | [* 1] Use the supplied allen key to tighten the set screw. The screw only needs to be snugly secured, do not tighen as hard as you can, it is only needed to hold it in place so about 1/2 turn past snug will be adequate. |
Image 1
No previous image
Added
Image 2
No previous image
Added