Changes to Step #6
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Install Heater Cartridge |
|---|---|
| + | [* 10] The main body of the hotend will come finger tight. Do not use this as assembled. |
| + | [* 1] First remove the nozzle (should only be on finger tight when taken from the kit). Then unscrew the heater block. Finally unscrew the heat break. You should have 4 seperate pieces. |
| + | [* 1] Insert the heater cartridge into the heater block with the legs of the wires coming out the direction as shown. The wires should be coming out the same side as the set screw for the thermistor as shown in pic 2. |
| + | [* 1] Tighten the screw to secure the heater cartridge in place. You can use a pair of pliers to hold the block in place while tightening the screw to secure the heater. |
Image 1
No previous image
Added
Image 2
No previous image
Added