Changes to Step #5
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Protect Crimps |
|---|---|
| + | [* 1] Locate the red silicone tube from the kit. Cut this tube in half so you have 2 pieces of equal length. |
| + | [* 1] Use a screwdriver on one end of a tube to help open up one side. This will help get the tube over the crimps you just installed. |
| + | [* 1] Slide one tube on one of the wires and work it down over the crimps until fully seated near the heater cartridge. Repeat this process on the other leg of the heater. |
| + | [* 1] Bend the leg of the cartridge so they are back in line with the cartridge. Pic 3 shows a fully prepped heater cartridge. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added