Changes to Step #2
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| [title] Prep Heater Cartridge | |
| - | [* 1] Start with the heating cartridge and remove the two tubes covering the legs of the heating cartridge |
| + | [* 1] Start with the heating cartridge and remove the two tubes covering the legs of the heating cartridge. *Note: some cartridges will not have these tubes, that is normal. |
| [* 1] Cut the legs of the heating cartridge to 11 mm. | |
| [* 1] Bend one leg of the cartridge 90 degrees away from the other leg. This will seperate them giving room to attach the crimp terminals. |