SeeMeCNC Guides
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Jim Macino —

Edit approved by Jim Macino

Before
After
Unchanged

Step Lines

[title] Prep Heater Cartridge
[* black] Start with the heating cartridge and remove the two tubes covering the legs of the heating cartridge
-[* black] Cut the legs of the heating cartridge to approximately the full length of the two crimp terminals included in the kit.
+[* black] Cut the legs of the heating cartridge to 11 mm.
[* black] Bend one leg of the cartridge 90 degrees away from the other leg. This will seperate them giving room to attach the crimp terminals.