Changes to this Step
Edit by D. Stark —
Edit approved by Tim Koscielny
- Before
- After
- Unchanged
Step Lines
| [title] Close Other APPs | |
| [* 9] Close other applications that may use the USB com port. | |
| [* 10] This printer is NOT designed to run from the USB port. Only connect the USB cable during setup of the printer. | |
| [* 10] The printer is designed to run from either (a) browser window over your intranet or (b) by addition of touchscreen with SD card reader | |
| [* 1] Close Cura, Mattercontrol, or other slicers you may have open. | |
| - | [* 1] Close any non-3D related programs, like Arduino or other programs that may use the USB |
| + | [* 1] Close any non-3D related programs, like Arduino or other programs that may use the USB COM port. |