Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #18

Edit by Caleb Fairres

Edit approved by Caleb Fairres

Before
After
Unchanged

Step Lines

[* black] You will now install the 3 idler assembles on the base plate. These are the assembles WITHOUT the motors.
[* black] Install the 3 side panels with the smooth side facing OUT, as shown in the photo.
[* black] Tabs in the plates of the assembly align with cutouts in the base plate. Press the assembly into these cutouts.
+[* black] You will secure each assembly with (2) 6-32 x 1" screws. This may be done easiest by cantilevering the base plate over the edge of a table. After you have all (6) screws started you can flip the assembly over and fully tighten.