Changes to this Step
Step Lines
| + | [title] Installing A Resistor in Fan |
|---|---|
| + | [* 10] NOTE: For this picture the fan has been removed from the side panel. |
| + | [* 1] You are going to install a resistor in line with the negative lead of the fan. This will slow the fan down and make it less noisy. |
| + | [* 1] Cut the negative (black) fan lead and in the middle. Slide heat shrink over both ends of the negative lead. |
| + | [* 1] Cut the resistor down (as shown) and solder in line. |
| + | [* 1] Slide the heat shrink over the exposed wire / resistor leg and heat it to shrink it over the component. |
Image 1
No previous image
Added