Changes to Step #34
Step Lines
+ | [title] Routing Belts |
---|---|
+ | [* black] Rotate the stepper motor to the position shown in the photo. This location will give you the most available range of motion for tightening the belts after they are installed. |
+ | [* black] Route the belt as shown in the diagram on step 16 |
+ | [* icon_caution] Be sure that the belt is not routed on the outside of the frame or carriage pieces! This will prevent motion. |
+ | [* black] To thread the belt ends into the carriage, use a wire tie or the cut-off from a wire tie to guide the belt up into the belt slot. |
+ | [* black] After you have threaded the belt into the carriage pull the belt end tight - you want to pull all the slack out of the belt. |
+ | [* black] Install the second belt clamp |
+ | [* black] You can trim excess belt, but leave approximately 1" past the belt clip. |
+ | [* black] Complete the routing process for the remaining two towers. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added