Changes to Step #54

Edit by Caleb Fairres —

Edit approved by Caleb Fairres

Before
After
Unchanged

Step Lines

[title] Install 60mm Fan
-[* 1] The fan should be installed so that it will blow OUT through the panel.
-[* 1] It is attached to the laser cut plate using (2) 6-32 x 1.75" screws, (2) rubber o-rings, and (2) nylon lock nuts.
+[* 1] The fan should be installed so that it will blow OUT through the panel. (The foil sticker is should be facing towards the laser cut panel)
+[* 1] It is attached to the laser cut plate using (2) M3 22mm socket head bolts, (2) rubber o-rings, and (2) nylon lock nuts.
[* 1] The o-ring is installed between the fan and the laser cut plate.