Skip to main content

Changes to Step #54

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* 1] Insert wisdom here.
+[title] Install 60mm Fan
+[* 1] The fan should be installed so that it will blow OUT through the panel.
+[* 1] It is attached to the laser cut plate using (2) 6-32 x 1.75" screws, (2) rubber o-rings, and (2) nylon lock nuts.
+ [* 1] The o-ring is installed between the fan and the laser cut plate.