Changes to Step #17
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| [title] Install Side Plate in Base | |
| [* 1] Install (3) of the prepared side plates in the base assembly. | |
| [* 1] Each side plate will be secured with (2) 6-32" screws coming up from the bottom. | |
| [* 1] Fully tighten all screws. | |
| + | [* 1] You will now install the 3 idler assembles on the base plate. These are the assembles WITHOUT the motors. |
| + | [* 1] Tabs in the plates of the assembly align with cutouts in the base plate. Press the assembly into these cutouts. |
| + | [* 1] You will secure each assembly with (2) 6-32 x 1" screws. This may be done easiest by cantilevering the base plate over the edge of a table. After you have all (6) screws started you can flip the assembly over and fully tighten. |
| + | [* 1] Insert nylon lock nuts into the side plate (as done in previous steps). You will use a total of (24) nylon lock nuts. |