Changes to Step #5

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Soldering Wires to Heated Bed
[* 1] Move the heated bed close enough to the printer that the wires will reach the pads that you have tinned.
-[* 1] Fan out the exposed strands of wire for the 12awg red and black wires. Solder them to the heated bed in the location indicated. NOTE: These are large wires and pads. You will need to ensure that the pads and wire strands get hot enough to wick the solder throughout resulting a good solder joint. Apply additional solder as needed.
+[* 1] Fan out the exposed strands of wire for the 12awg red and black wires. Solder them to the heated bed in the location indicated ( The - pad and the 2+ pad) NOTE: These are large wires and pads. Ensure that the pads and wire strands get hot enough to wick the solder throughout resulting a good solder joint. Apply additional solder as needed.