Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by Jim Carter

Edit approved by Jim Carter

Before
After
Unchanged

Step Lines

+[title] GCode???
+[* black] The tab labeled GCode should really have a different title, but follow these settings for the v3.
+[* black] The Z-Axis Offset will vary for everyone. If after running a full calibration on the printer before your first print with these settings you find that the nozzle is a bit too close to the bed, start low and work your way up .01mm at a time in the called out section.

Image 1

No previous image

Added